Device: KeyMander 2
KM2 Blinking Red
Hello, I’ve just received the Keymander 2 Mobile & would love to try it. I’m following the video provided for setup, however I’m not able to get to the pairing stage as the device continues to blink red, & turn off & back on & so on.
From my understanding this may be a lack of power issue, but I’ve tried running it through iPhone block charger, directly into an adequate power bar USB slot, & directly into wall outlet through charging block. All of the above should be enough juice to power the device so I’m stuck.
Would love to get it sorted & keep the device if possible, any suggestions would be very much appreciated. Thank you
- J
08/21/2024 6:05 PM
Hello,
I personally would recommend a power adapter of at least 5V 2.4A as I've encountered this with some power-hungry keyboards on the smaller voltage power adapters.
It could also help to make sure that the controller is fully charged.
If you get it to go green but cannot activate the bluetooth discoverable mode (F2), please try another keyboard as that's usually an indicator of an unsupported keyboard.
08/23/2024 9:21 AM
Add a comment
Add a comment